What Should a Roofing Estimate Include? A Homeowner Guide
What should a roofing estimate include? At a minimum: the full scope of work, the materials named by product, whether the old roof is torn off, the underlayment and flashing to be installed, how ventilation is handled, the price for replacing damaged decking, cleanup and disposal, the schedule, the payment terms, the warranties and proof of license and insurance. An estimate that gives one total and a line reading "replace roof" cannot be compared with anything, and it leaves every later disagreement open.
This guide goes through each part of a complete estimate, explains how hidden damage and payments should be handled, and shows how to compare bids and spot the warning signs.
What should the scope of work spell out?
Everything that will be removed, installed and cleaned up, in enough detail that two people would read it the same way.
- The roof areas included, and any that are not, such as a porch, shed or detached garage
- Whether the old roofing is torn off to the deck, and how many layers are being removed
- Ice and water barrier: where it goes, such as eaves, valleys and around penetrations
- Underlayment type across the rest of the deck
- New drip edge, flashing, pipe boots and vents, or a clear statement of what is reused
- Ridge caps and starter shingles
- Protection of landscaping, siding and windows
- Cleanup, magnetic nail sweep and disposal
- Permit, if one is required, and who obtains it
Flashing is the item most often left vague. Ask directly whether the chimney, wall and valley flashing will be new. The company's page on tear-off and new roof installation describes what a full replacement covers.
How should the materials be described?
By manufacturer, product line and color, not by a general term. "Architectural shingles" covers a wide range of quality.
- Shingle manufacturer, product line and color
- Impact and wind ratings, where they matter to you or your insurer
- Underlayment and ice and water barrier by product
- Type and number of vents
- Metal type and color for drip edge and flashing
- Quantity basis, usually the roof area in squares
Named products let you look up the manufacturer's specifications and warranty, and they let you check the delivery against the contract on installation day.
How should hidden deck damage be priced?
With a stated unit price, agreed before the work starts. Nobody can see the whole deck until the old roof is off, so a good estimate says what happens when damage is found.
- A price per sheet of plywood or per foot of board replaced
- Whether any amount of decking is already included in the total
- How you will be told, ideally with photos, before extra work is done
- Who approves the change and how it is recorded
North Point Roofing LLC states on its site that its quote is full and complete, with no surprises when the job is done, and that it documents each phase with before-and-after photos. Whichever roofer you choose, the decking price belongs in writing.
What should you expect on a roofing deposit and payment terms?
Clear terms tied to progress. A roofing deposit varies from company to company, and the estimate should state exactly what is due and when.
- The amount due at signing, if any
- Payments tied to milestones such as material delivery or completion
- The final payment due after the work is finished and inspected
- Accepted payment methods
- How changes to the price are approved
Be wary of a demand for full payment before work begins. North Point Roofing LLC states on its site that it offers clear contracts with no hidden charges and zero upfront deposit. Ask any contractor to put its payment schedule in the contract.
What warranty and insurance details belong in the estimate?
Two warranties and two kinds of insurance, each named.
- The manufacturer's warranty on the materials, with the product it applies to
- The contractor's workmanship warranty, with its length and what it covers
- What voids either one, such as inadequate ventilation or unapproved repairs
- A current contractor license, which you can verify with the state
- Liability insurance
- Workers' compensation coverage, so an injury on your property does not become your liability
Ask for certificates of insurance sent from the insurer, and for the workmanship warranty in writing with its exact term. The company's site says it is fully licensed and carries workers' compensation insurance.
How do you compare roofing estimates?
Line by line, after making the scopes match. Knowing how to compare roofing estimates matters more than collecting many of them.
- Put the estimates side by side and mark what each includes
- Confirm the same tear-off, underlayment, flashing and ventilation work in each
- Compare the named shingle products, not just the word "shingles"
- Check the decking unit price in each
- Compare warranty terms and payment schedules
- Ask the low bidder what is not included
- Ask each contractor how long the job will take and who supervises it
The lowest total is often the estimate with the most left out. A somewhat higher bid that renews the flashing and names every material can be the better value. Use the list above as a roofing contract checklist when the estimate becomes a contract.
What are the red flags in a roofing estimate?
Vagueness and pressure. Either one is a reason to slow down.
- A single lump sum with no description of the work
- No product names
- No mention of flashing, underlayment or decking
- A large cash deposit or full payment up front
- A price that is good only if you sign today
- No physical address, license number or proof of insurance
- A promise to cover your insurance deductible
- Reluctance to put changes in writing
A contractor who is confident in the work will explain every line. The services North Point Roofing LLC provides are listed on its roofing installation page.
Frequently asked questions about roofing estimates
How many roofing estimates should I get?
Two or three from established local contractors are usually enough to see the range and to notice what one of them left out. More than that rarely adds information if the scopes are written clearly.
Are roofing estimates free?
Many roofers provide them at no charge, and it is worth confirming when you call. North Point Roofing LLC states on its site that it offers free estimates.
What is the difference between a roofing estimate and a contract?
An estimate describes the proposed work and its price. A contract is the signed agreement that binds both sides, and it should repeat the scope, the materials, the price, the payment schedule, the timeline and the warranties from the estimate.
Can the price change after I sign?
Only for reasons the contract allows, such as damaged decking found after tear-off, priced at the unit rate agreed in advance. Any other change should be written down and approved by you before the work is done.
Request an estimate from North Point Roofing LLC
North Point Roofing LLC is a roofing contractor based in Ogden, UT that offers roof installation, tear-off and replacement, roof repair, metal roofing, cedar shakes, TPO and heat cable installation. It serves Ogden, North Ogden, South Ogden, Farmington, Bountiful and Centerville, with local pages such as roofing contractor in South Ogden, UT. To request a written estimate for your roof, call 385-298-2310 or contact North Point Roofing LLC.
